Clayground
SearchSculpt free

Make a Kiln Cup track

How the track maker works

A new track starts as a friendly oval on a map seen from above. Drag a point to bend the road, tap the road to add a point, or press Draw and trace a loop with a finger or a mouse: the road follows the way you went, and the start line goes where the road is straightest.

Pick one of six places (Meadow, Canyon, Lagoon, Dusk, Frost or Ember) for the look, the sky and the music. Each point can be wider or narrower, and higher or lower; the map gets paler where the road climbs. Raise, Dig, Smooth and Level shape the land around the road in clay, Paint colors it (sand, dirt, moss, snow, rose or ash), and the map shows both. Press Look to ride round it in its place, and Shuffle for a loop and land nobody made.

Make one in a few minutes

  1. Shape the road. Red rings mark a bend too tight for the road's width, a place where the road runs into itself, or a lap that is too short or too long. Fix it eases out a tight bend for you; a crossing is yours to move.
  2. Name it and press Save and race. Before a track is kept, eight computer karts drive once round it; if any gets stuck, a gold ring shows where.
  3. Your track joins the eight house tracks in the Kiln Cup garage, with its own best time. Tap the pencil to change it later. The garage keeps six of yours.

Questions people ask

Is the track maker free?

Yes, like everything in Kiln Cup. Your tracks are kept in this browser, with no account.

Why will it not let me save?

A road has to be one that karts can drive: no bend tighter than the road is wide, no crossing itself, and a lap between 320 meters and 3.2 kilometers. The status under the name says which.